Maintenance of oil drilling solids-control equipment?

　　 Oil Drilling Solid Control Equipment As a large-scale specialized piece of equipment, it is frequently subjected to heavy loads, and over time its components are prone to wear and other forms of failure. To ensure the equipment operates properly, it is essential to strengthen routine maintenance and upkeep of oil-drilling solids-control equipment. In this article, we will provide a detailed overview—let’s explore it together with the editor. We hope this information proves helpful.

　　First, upon arrival of the mud purification system for oil drilling solids-control equipment at the job site, the user shall position, connect, install, and support the equipment in accordance with site conditions. As this equipment is only a component of the drilling-fluid purification circulation system, its primary functions are to purify and prepare the drilling fluid and to store it on-site. After connecting the equipment to the mud outlet of the rig stand, the user must provide a mud storage tank or mud pit to accommodate additional mud, thereby ensuring an adequate supply of drilling fluid for the rig.

　　Thirdly, each auxiliary unit of the oil drilling solids-control system is independently started and shut down, ensuring no interference among them. Users can select any combination of solids-control equipment based on the drilling-fluid conditions. Once drilling commences and the drilling-fluid supply is stable, the system will operate normally.

　　It should be noted that when using a mixing hopper with oil-drilling solids-control equipment, the feed butterfly valve must first be closed. Only after the pressurized drilling fluid has begun to discharge normally from the outlet should the feed butterfly valve be reopened to halt the feeding operation. The weighing hopper is of a cyclonic design; during feeding, the hopper should be fed intermittently to prevent backflow of the mud. If discharge is obstructed or blockage occurs, feeding should be reduced or stopped immediately, and any malfunctions caused by other solids-control equipment should be promptly rectified.

　　 Oil Drilling Solid Control Equipment When the Drilling fluid shaker is out of service, it should be immediately rinsed clean with water, and it is strictly forbidden to use metal tools to remove debris from the screen. Before starting the mud mixer, first check whether there is sufficient lubricating oil in the gearbox and add enough according to regulations. When sand cleaning or high-pressure mud circulation stops, first open the valve of the jet pipeline, then open the main valve of the upstream pipeline. When stopping the suspension, first close the main valve, then close the valve of the jet pipeline to prevent the high pressure in the jet pipeline from being shut off. During drilling, the mud loss and solid particle content directly affect the quality of the mud cake formed on the borehole wall. Low mud loss, a thin and tough mud cake, and good borehole stabilization are our goals.

　　We are a reputable manufacturer of oil-drilling solids-control equipment. If you’re looking to place an order, feel free to browse our selection—we’re confident you won’t be disappointed. Our equipment is offered at competitive prices, with guaranteed quality, and comes in a wide variety of models, so there’s sure to be one that meets your needs. We welcome you to visit and make your purchase.